|
Hatco Water Level Control Board
The transformer may go bad or a solder joint is a
common problem on circuit boards. |
Hatco Warmer Bulb
When ordering replacement bulbs you may want to get
a few extra to be safe! |
|
Hatco Contactor
When a contactor fails the transformer may fail or
the points on the wire connectors may be bad. |
Hatco Booster Heater Element
Elements can burn out over time. If the element
breaks apart during failure it is important to
remove all particals from water tank. |
|
Hatco Warmer Element Rod
Take special note of the voltage and wattage stamped
in the element rod when replacing. |
Hatco Booster Heater Fuses
It is a good idea to have spare fuses on any
equipment requiring them. |
|
Hatco High Limit Cut Out
The high Limit is a safety that will shut down the
system if thne unit is getting to hot. |
Hatco Knob
Control knobs can break or become dirty over time.
Give your unit a fresh look with a new control knob. |
|
Hatco Toaster Motor
If your conveyor has stopped moving the speed
control may be bad or the motor is burnt out. |
Hatco Booster Heater Relief Valve |
